1400 SERIES MOTORS

Neu BLDC 1400 series innrunner

 

    1400 Motors:

    1400 series brushless motors are manufactured in a wide variety of lengths and winds to provide increasing power ratings at a number of voltages. Select the desired motor power range from the table below.

    • Inrunner construction
    • High speed operation – 60,000 RPM
    • 4 poles / 12 slots
    • 5mm shaft

    Options:

    May be mated with P32 integral gearboxes for very high power-to-weight drives.

    14xx Series Power Range

    See the tables below for kV and torque ratings.

     


    1406: 450-900 watt brushless motors


    1409: 700-1.400 watt brushless motors


    1412: 950-1,900 watt brushless motors


    1415: 1,100 – 2,200 watt brushless motors


     

    POWER RATINGS (Watts):

    • Continuous rating is the power the motor can deliver while maintaining the external housing temperatures below 100C.
    • MAX power rating is the power the motor can deliver beginning with motor at a temp of 20C until it reaches it's limit temperature of 100C.
    • The ratings are therefore dependent on a number of variables including air flow, ambient air temperature, contact cooling etc.

    MTBF RATINGS:

    When used within the constraints described above, BLDC motors' primary "wear" item(s) are the bearings supporting the shaft. Bearing life is inversely affected by speed, temperature, and radial and axial loads.  While an MTBF figure can be generated, it would be rendered invalid by excursions beyond prescribed temperatures or load limits - such as prop strikes, or side loads.  MTBF must be determined on a case by case basis, and even then, it would be subject to numerous exceptions.

    MAX VOLTAGE

    Limited by kv (RPMs per volt) times the applied voltage.  Max voltage must be kept below the voltage which will spin the motor over max rpm for the motor series.

    MAX AMPERAGE

    See power ratings above.

    COMPONENT SPECIFICATIONS

    • Winding temperature:  -- 180C
    • Magnet grade: - 180C UH grade
    • Bearings:  Japanese SPB bearings