APD 200F3x ESC

$289.00

SPECIFICATIONS: 

The improved F_Series 200F3[X] ESCs build upon our trusted ARM 32-bit architecture. The V2 release introduces a number of highly requested features into the product range, including configuration options and additional drive modes. The 200F3[X]v2 ESCs are drop-in replaceable to 200F3[X] units. As before, existing features include PWM-frequency dithering and Active Phase-Current Demagnetisation, allowing for smooth control with virtually all powertrain combinations with peak power outputs of up to 18 kW.

March 2023 Feature Set (V2)

Configuration of drive parameters, signal types and fault handling

On board bootloader

Additional Telemetry types: PWM Telemetry and RPM Output

High-speed telemetry rates when operating DShot

Reversible operation support (full forwards to full reverse)

Dynamic signal quality checks across supported input protocols

Feature Set

Designed and manufactured in Australia using only the highest quality components, ensuring no sacrifice in reliability

Proprietary firmware designed in Australia

Plug and play firmware

Up to 14S (60 V) capable

Up to 200 A continuous* output current

300 A Burst current

True 10-bit resolution

Virtually no setup time, with simple motor reverse solder tab

Auto-detect PWM or DShot

DShot150 to DShot600 capable (0.15-0.6Mbs/s)

Up to 750,000 eRPM (protocol dependant)

Motor agnostic

Auto PWM output frequency

Auto timing advance

Telemetry output

Automatic current limiting and over-temperature protection

LED indication

Digital commands over ProShot (including anti-turtle mode)

Digital commands over DShot

Bare-PCB design to allow maximum integration within the end setup

8-Layer PCB to ensure minimal track resistance

 

* Continuous current ratings are at a 100% throttle duty cycle. Continuous rating is defined as max sustained current at 100% throttle for 60 seconds with 33 m/s of airflow.

 

Peak power ratings defined at 100% throttle, where bus current = phase current. Requires proper sizing of motor to load. 

(*) Continuous amps defined as amperage sustainable for 180 seconds with adequate cooling to keep ESC at or below 115C

(**) Burst amps defined as amperage sustainable without damage to controller for a period of 5 (five) seconds.  Burst should not be encountered again until ESC has returned to normal temperature

(***) Weight refers solely to the circuit board and enclosure, if any.  Weight measured without any wires or connectors.

Specifications subject to change without notice.