APD 40F3x ESC
$75.00
Back in production as of OCT 2023.
4 in stock
SPECIFICATIONS:
| Peak Power Rating (kW) | 2.5 | Weight (no cables) (g) | 3 | |
| Continuous Current (A) | 40 | Dimensions (mm) | 31 × 16 × 4 | |
| Continuous Rating Duration (s) | 180 | Input signal PWM frequency | 1000 | |
| Burst Current (A) | 100 | Input PWM frequency pulse width (ms) | 300 to 1200 | |
| Burst Rating Duration (s) | 5 | Motor de-sync protection | NO | |
| Max Voltage (V) | 25 | Auto motor PWM-Freq | YES | |
| Max No. of LiPo Cells | 6 | Regenerative braking | YES | |
| Min Voltage (V) | 6 | Max Regen Current (A) | 18 | |
| Min No. of LiPo Cells | 2 | Max Regen Voltage | 110% Power on Voltage | |
| Max ERPM | 750,000 | Auto Timing Advance | YES | |
| Resistance (Ohms) | 0.0014 | Configurator Tool | NO | |
| Input Resolution | Data Logging (Black Box) | NO | ||
| Max Operating Temperature (⁰C) (50% current limit start point) | 115 | Bi-Directional Control | NO | |
| Recommended Airflow to achieve max power ratings (m/s) | 10 | Micro USB Firmware Flashing | NO USB port on ESC. ESC may be addressed using external adapter | |
| Decoupling Capacitor | 1 X 100uF 35V | Micro USB Firmware Flashing | NO USB port on ESC. ESC may be addressed using external adapter | |
Peak power ratings defined at 100% throttle, where bus current = phase current. Requires proper sizing of motor to load.
(*) Continuous amps defined as amperage sustainable for 180 seconds with adequate cooling to keep ESC at or below 115C
(**) Burst amps defined as amperage sustainable without damage to controller for a period of 5 (five) seconds. Burst should not be encountered again until ESC has returned to normal temperature
(***) Weight refers solely to the circuit board and enclosure, if any. Weight measured without any wires or connectors.
Specifications subject to change without notice.