APD 80F3x ESC
$89.00
SPECIFICATIONS:
| Peak Power Rating (kW) | 4 | Weight (No cables) (g) | 10 | |
| Continuous Current (A) | 80 | Dimensions (mm) | 51 x 23 x 14 | |
| Continuous Rating Duration (s) | 180 | Input Signal PWM Frequency | 1000 | |
| Burst Current (A) | 140 | Input PWM Frequency Pulse Width (ms) | 300 to 1200 | |
| Burst Rating Duration (s) | 5 | Motor De-sync Protection | NO | |
| Max Voltage (V) | 35 | Auto Motor PWM-Freq | YES | |
| Max No. of LiPo Cells | 8 | Regenerative Braking | YES | |
| Min Voltage (V) | 9 | Max Regen Current (A) | 10 | |
| Min No. of LiPo Cells | 4 | Max Regen Voltage | 110% Power on Voltage | |
| Max ERPM | 750,000 | Auto Timing Advance | YES | |
| Input Resolution | 10 bit | Stall Protection | YES | |
| Resistance (Ohms) | .0013 | Configurator Tool | NO | |
| Max Operating Temperature (⁰C) (50% current limit start point) | 115 | Data Logging (Black Box) | NO | |
| Recommended Airflow to achieve max power ratings (m/s) | 10 | Bi-Directional Control | NO | |
| Decoupling Capacitor | 1 x 330uF 50V | Micro USB Firmware Flashing | NO |
Peak power ratings defined at 100% throttle, where bus current = phase current. Requires proper sizing of motor to load.
(*) Continuous amps defined as amperage sustainable for 180 seconds with adequate cooling to keep ESC at or below 115C
(**) Burst amps defined as amperage sustainable without damage to controller for a period of 5 (five) seconds. Burst should not be encountered again until ESC has returned to normal temperature
(***) Weight refers solely to the circuit board and enclosure, if any. Weight measured without any wires or connectors.
Specifications subject to change without notice.