APD HV PRO 16 BRUSHLESS ESC
75V 400 Amps
![](https://neumotors.com/wp-content/uploads/2020/01/logoHVPRO_400_400.png)
![](https://neumotors.com/wp-content/uploads/2020/01/HV_Pro24S.jpg)
![HVPRO SERIES 644](https://neumotors.com/wp-content/uploads/2020/01/HVPRO-SERIES-644.png)
$1,899.00
SPECIFICATIONS:
APD HVPRO 16S | ||||
Peak Power Rating (kW) | 30 | Weight (No cables) (g) | 155g | |
Continuous Current (A) | 400 | Dimensions (mm) | 96 × 52 × 22 | |
Continuous Rating Duration (s) | 180 | Input Signal PWM Frequency | Up to 500Hz | |
Burst Current (A) | 600 | Input PWM Frequency Pulse Width (ms) | 1000μs to 2000μs (Adjustable) | |
Burst Rating Duration (s) | 5 | Motor De-sync Protection | YES | |
Max Voltage (V) | 60 | Auto Motor PWM-Freq | YES | |
Max No. of LiPo Cells | 14S | Regenerative Braking | YES | |
Min Voltage (V) | 15 | Max Regen Current (A) | 30 (10% max set current) | |
Min No. of LiPo Cells | 5S | Max Regen Voltage | 110% Power on Voltage | |
Max ERPM | 1,000,000 | Auto Timing Advance | YES | |
Resistance (Ohms) | .00018 | Stall Protection | YES | |
Input Resolution | 12 bit (0.02%) | Configurator Tool | YES | |
Max Operating Temperature (⁰C) (50% current limit start point) | 115 | Data Logging (Black Box) | YES | |
Recommended Airflow to achieve max power ratings (m/s) | 10 | Bi-Directional Control | YES | |
Decoupling Capacitor | Not Included | Micro USB Firmware Flashing | YES | |
RPM OUTPUT | YES |
MODES
Normal mode: Incremental + Linear power ramp control
Used with:
Fixed wing aircraft
Watercraft
Paragliders
Multi-Rotor: Instantaneous Input = Output Step Response
Used with:
Drones
Flying Cars
Heli: Soft-start for drive-train protection
Used with: Helicopters
Traction: Same as normal except for active torque control, which applies a motor phase current limit that ramps proportionally with higher motor duty-cycles
Used with: Electric bikes
Reverse: Normal mode with reverse capabilities
Used with: Watercraft requiring reverse
HV PRO CONFIGURATOR
Windows Configuration Tool allows users to update ESC, configure settings, and access data logs.
![](https://neumotors.com/wp-content/uploads/2020/02/WD_HV_Pro-Wiring-Diagram.png)
HIGHEST QUALITY AND EFFICIENCY
Designed and manufactured in Australia using the highest quality components. APD uses aerospace grade ceramic capacitors for the lowest possible ESR and maximum reliability.
PWM-frequency dithering to avoid PWM-commutation synchronisation.
Adaptive motor timing advance and proprietary developed Active Phase-Current Demagnetisation (APCD). APCD along with synchronous rectification ensures maximum ESC efficiency.
Peak power ratings defined at 100% throttle, where bus current = phase current. Requires proper sizing of motor to load.
(*) Continuous amps defined as amperage sustainable for 180 seconds with adequate cooling to keep ESC at or below 115C
(**) Burst amps defined as amperage sustainable without damage to controller for a period of 5 (five) seconds. Burst should not be encountered again until ESC has returned to normal temperature
(***) Weight refers solely to the circuit board and enclosure, if any. Weight measured without any wires or connectors.
Specifications subject to change without notice.